Careers
Electronics
Hardware Design Engineer
Core Skills
- End-to-End Hardware Architecture (FC, ESC, Power Systems)
- Mixed-Signal Design (Analog + Digital Integration)
- High-Reliability Circuit Design (Defense-Grade)
- Real-Time Embedded Hardware Co-Design
- Sensor Interface Design (IMU, GNSS, LiDAR, Vision Modules)
- High-Current Design (100A–1000A Systems)
- BLDC Motor Control Hardware (ESC Design, Gate Drivers, FOC Basics)
- Battery Management Systems (BMS)
- Power Distribution Architecture for Multi-Motor Drones
- Thermal-Aware Power Design & Efficiency Optimization
- Communication Protocols: UART, SPI, I2C, CAN/CAN-FD
- MAVLink, PWM, PPM & DShot Integration
- Ethernet for High-Speed UAV Data Systems
PCB Design Engineer
Core Skills
- Multi-Layer PCB Design (6–12+ Layers, High-Density Layouts)
- High-Speed Routing (DDR3/DDR4/DDR5 Interfaces)
- Ethernet, USB, PCIe & SATA High-Speed Interfaces
- LVDS / FPD-Link & MIPI CSI/DSI Interfaces
- Differential Pair Routing (Length Matching & Skew Control)
- Controlled Impedance Routing (50Ω / 90Ω / 100Ω)
- Return Path & Reference Plane Management
- Signal Integrity & Power Integrity (SI/PI Analysis)
- EMI/EMC Compliance (Military-Grade Robustness)
- Thermal Management in PCB Design
- Camera & Vision System Interface Integration
- High-Speed Storage & Data Communication Systems
- Advanced PCB Optimization for Embedded & UAV Systems
RF System Designer
Core Skills
- End-to-End RF Architecture (Tx/Rx Chain, Front-End Design)
- Antenna Integration & Impedance Matching (S11, VSWR Optimization)
- Multi-Band RF Systems (GNSS, Telemetry, Control Links)
- RF Link Budget & Range Optimization
- Low-Noise RF Design (LNA, Filters, Noise Control)
- Multi-Constellation GNSS (GPS, GLONASS, Galileo, BeiDou)
- GNSS Noise Mitigation & Filtering
- EMI/EMC Design for Aerospace Systems
- RF Shielding, Grounding & Isolation
- Interference Mitigation for ESC & Power Electronics
- Anti-Jamming & Anti-Spoofing Fundamentals
- RF Measurements (VNA, Spectrum Analyzer, Power Meter)
- RF PCB Layout & Impedance-Controlled Routing
Test Engineer
Core Skills
- Hardware Bring-Up (Complex Multi-Board Systems)
- Environmental Testing (Thermal Cycling, Vibration, Shock)
- HALT/HASS & Reliability Qualification
- Failure Analysis & Root Cause Debugging (RCA)
- Lab Expertise: Oscilloscope, Spectrum Analyzer & VNA
- Power Testing & Validation
Product Engineer
Core Skills
- Design for Manufacturing (DFM) & Assembly (DFA)
- PCB Fabrication & Assembly (SMT, Reflow, Rework)
- Production Scaling & Cost Optimization
- Reliability Engineering (MTBF, Derating Techniques)
- Technical Documentation (Schematics, BOM, Test Procedures)
Share your CV
